Highlights
- Prepares 3D models for printing through a slicer workflow.
- Allows print settings to be adjusted before output is created.
- Generates layered instructions for use with a 3D printer.
- Runs on Linux according to the listed platform data.
About this application
OrcaSlicer is a Linux application for preparing 3D printer jobs. It takes a 3D model and turns it into sliced print instructions, letting the user adjust print-related settings before sending or saving the result for use with a printer. Its role is to bridge the gap between a model file and the layered toolpath that a printer can follow.
The program is published by SoftFever and distributed under the AGPL-3.0-only license. It is intended for users who need control over print preparation rather than only viewing or storing models. The available platform information here lists Linux, so users of other operating systems should not assume support from this entry alone.
Where to get it
Linux
- Open on FlathubOpens in a new tabPackage repositoryFlathub
From the publisher
Install from a terminal
flatpak install flathub com.orcaslicer.OrcaSlicer
We do not host this file, we do not scan it and we do not inspect its contents. Read what the source says, then decide for yourself.